5 cards with 1 Sheet DSP

Hey there.  Do you have problems trying to figure out what to do with those sheets of DSP that are broken up into segments of different pictures?  Like this one?

This is a sheet of the Lovely Blossoms Designer Series Paper.  I love the colors and prints in this pack of paper, and I've used some of it already.  But it comes with 3 sheets of this design, and it's been a struggle figuring out what to create with it.  All the images are lovely, but I'm more used to stamping or die-cutting the focal pieces on my cards and not just using something ready-made.  So, I chopped this one up and got ready to create with these pieces.  The 2" x 12" section along the bottom didn't get cut into 2" squares but left long.  I turned it over and used the flip side of the design.  Let's see what I came up with, and you can decide if it all worked out well.

Let's start with the design in the top left corner and continue from there.  This piece of the design measured 6" x 4".  It's trimmed down to 5 1/8" x 3 3/4" to fit a card front.  There is a layer of Cloud Cover behind it that measures 5 1/4" x 3 7/8".  This is just enough to give it a skinny frame of color.  The card base is Old Olive cardstock that measures 8 1/2" x 5 1/2".  It's scored and folded in half.

After attaching the print to the Cloud Cover layer, a piece of Secret Sea Bordered Open Weave Ribbon was wrapped around and tied into a bow.  Then the layers were attached with Dimensionals to the card base.

The sentiment is from the Banner Sayings stamp set.  I intended to use the full sentiment but ended up trimming between the words to get a smaller banner.  This is curled at the left edge a little and attached at the right edge only.

There are three of the green Moody Palette Glossy Dots used as an accent to the design. 

This is the 2nd design across the DSP.  Again, it measures 6" x 4".  The Textured Notes die was used to cut out the design.  Then the DSP was turned over and trimmed to have the DSP measure 5 1/2" x 4" with the die-cut area centered on the paper.  This was attached to a Secret Sea cardstock piece that measures 8 1/2" x 5 1/2" and is folded in half.  

The die cut piece was attached in the center to cover the hole using Dimensionals.  Looking at the card at an angle you can see a slight edge of the Secret Sea peeking through.

The sentiment is stamped onto a Basic White die-cut using the Textured Notes dies.  It's stamped with Secret Sea ink.  A double bow of Linen Thread was added to the corner.

Three of the Secret Sea dots from the Moody Palette Glossy Dots were added for contrast.

The next card is the 6" x 4" design in the right top corner of the DSP sheet.  This was trimmed to 5" x 3 3/4".  It's layered onto a Secret Sea cardstock piece measuring 5 1/4" x 4".  A length of Secret Sea Bordered Open Weave Ribbon was wrapped around this and tied into a knot.

A card base was made from an 8 1/2" x 5 1/2" Petal Pink cardstock that was folded in half.  The layers were attached to this with adhesive.

The sentiment is from Banner Sayings and punched with the Three Banner Punch.  This was tucked under the knot in the ribbon and attached with adhesive.

Three of the white Moody Palette Glossy Dots were added to the design for interest.

Now we move down to the next row in the DSP design. This piece measured 3" x 4".  There is a layer of Secret Sea cardstock that's cut at 3 1/4" x 4 1/4".

A card base was made from Crumb Cake cardstock and measures 8 1/2" x 5 1/2".  The bottom 2" strip of DSP was trimmed to 5 1/2" and attached along the left side of the card base using adhesive.

The layers were attached to the card base with Dimensionals.  The sentiment is from Banner Sayings and is stamped with Secret Sea ink onto a 1/2" white strip.  The ends were angle cut with scissors.  Then it was attached with Dimensionals.  Three Secret Sea Moody Palette Glossy Dots were added to the design.

This last card I made has a design piece that was trimmed to 3" x 3 3/4".  It's layered onto a Secret Sea piece that measures 3 1/4" x 4".

The card base is Cloud Cover that measures 8 1/2" x 5 1/2".  Another piece of the 2" wide strip of DSP was trimmed at 5 1/2".  This was attached on the left side of the card base using adhesive.  The focal image layers were attached to this with adhesive also.

The sentiment is from Banner Sayings again.  It's also trimmed at an angle with scissors.  Then it's attached to the card front with Dimensionals.  Three Secret Sea color gems from the Moody Palette Glossy Gems were added to the design.

Here's another quick look at the five cards I made from this one piece of the Lovely Blossoms DSP.  Seeing them all together, I think they'd make a really nice gift tucked inside a card holder that matched.  Hmmm, I'll have to consider that.  

There are still two pieces of the sheet of paper left that I have no plans for yet.  That will take a bit more thought also.  Hope you liked these card ideas.  They were a pretty easy way to get a card assortment done quickly.  If you don't need thank you cards, just change the sentiments to what you need.  They are all simple but pretty and I think they would definitely brighten the day of anyone receiving them.  

Have you heard about the free shipping Stampin'Up! is giving us?

There is Free Shipping for 3 days!  From February 18 to 20, you can shop and save on all qualifying orders of $75 or more.  You won’t want to miss this chance to stock up on all your favorite products from the catalog, Online Exclusives, kits, and more!

Plus, when your order total reaches $75 (after subtracting any rewards) you are eligible to purchase the Product of the Month for only $5 which is an awesome pack of the Painted Illusions Designer Series Paper!  This is a doubly - great bargain for you.

Thanks for sharing some time with me today.  If I can help you in any way, just get in touch.  I'd be happy to be your demonstrator if you're looking for one!

Happy stamping and creating,

Sharon